INSTALLATION INSTRUCTIONS
For PDM, TSK44/45 replaces Toyota part #31230-60241
Fits Toyota FJ Cruiser, Tundra, & Tacoma 2005-14 w/V6
Remove old clutch release bearing and fork. De-burr the quill with carb/brake cleaner and Scotchbrite. Thoroughly clean the quill before installing. Slide the PDM sleeve over quill until seated against bell housing. If necessary, TAP it on, use a punch or chisel against the shoulder of the sleeve to walk it on. DO NOT USE EXCESSIVE FORCE!! The material is thin where the quill meets the bell housing. Excessive force can break the quill off. Be careful not to damage the threaded holes. Install set screws with blue Loctite. ***DO NOT OVERTIGHTEN SCREWS***
Coat inside of bearing with supplied grease. It is extremely important that the grooves be filled; these are a reservoir for the grease. Use remaining grease to create film on the sleeve and to lubricate the fork pivot ball.
Install bearing on fork and reinstall.
ADJUST CLUTCH AS SPECIFIED BY MANUFACTURER!!!!!!!!
Attach the included label on the right shock tower.